Xinje ZG3-30T - Page 46

SD1080
Current segment(No. n segment)
PULSE_5
SD1082
Low 16 bits of accumulated pulse
number (the unit is pulse number)
SD1083
High 16 bits of accumulated pulse
number (the unit is pulse number)
SD1084
Low 16 bits of accumulated pulse
number(the unit is pulse equivalent)
SD1085
High 16 bits of accumulated pulse
number(the unit is pulse equivalent)
SD1086
Low 16 bits of current output
frequency(the unit is pulse number)
SD1087
High 16 bits of current output
frequency(the unit is pulse number)
SD1088
Low 16 bits of current output
frequency(the unit is pulse equivalent)
SD1089
High 16 bits of current output
frequency(the unit is pulse equivalent)
SD1090
Wrong Pulse message
1： Pulse data block error
2 ： Equivalent mode ： pulse
amount/turn 、 amount/ turn of
movement is 0
3:Code of system parameters block
error
4：Pulse data block exceeds max
limit
10：Zero return do not set near point
signal
11：Speed of zero return is 0
12：Crawling speed of zero return is
0
13 Direction of zero return speed and
zero auxiliary speed
SD1091
Code of error pulse block
SD1100
Current segment(No. n segment)
PULSE_6
SD1102
Low 16 bits of accumulated pulse
number (the unit is pulse number)
SD1103
High 16 bits of accumulated pulse
number (the unit is pulse number)