Need help?Do you have a question about the Xnexus NXT200 AC/DC and is the answer not in the manual?
Covers electrical, light, gas, fire, and noise hazards during operation.
Discusses conformity, potential disturbances, and methods to reduce emissions.
Instructions for connecting the machine to power, gas, and welding cables.
Guidance on settings, remote control connection, and operating procedures.
Recommended annual cleaning, checks, and factory calibration.
Lists voltage, duty cycle, current ranges, dimensions, and weight for NXT200.
Lists voltage, duty cycle, current ranges, dimensions, and weight for NXT250.
Explains the purpose of each pin in the 7-pin remote connector.
How to set and view machine parameters using controls and the display.
Selecting MMA, TIG AC/DC, TIG DC and ignition methods (HF/LIFTIG).
Explanation of the basic trigger operation for welding.
Details on Four-times process and second current level.
Internal, foot, and torch adjustment options for welding current.
Descriptions of Pre-flow, Start Amp, Slope-up, Slope-down, Stop Amp.
Setting post-flow, pulse modes, and TIG AC balance.
Adjusting pulse time, pause time, and base amp for pulse welding.
Steps to restore default machine settings and parameters.
General| Output Current | 200 A |
|---|---|
| Protection Class | IP21S |
| Input Voltage | 230V AC ±15% |
| Duty Cycle | 60% at 200 A |
| Output Current Range | 20-200 A |
| Open Circuit Voltage | 65 V |
To Next Page
