NATURAL GAS CONNECTION KIT INCLUDED
Grills and griddles models for Natural Gas come with the correct orifices, air shutter settings,
regulator and elbow necessary to attach the unit to your gas supply.
The gas griddle manifold ends in a 1/2” male thread and Grip Nut for a wrench.
Connect the brass elbow to the end of the manifold - using a wrench on the manifold to
prevent it from turning while tightening the elbow.
Use plumbers putty or gas tape to seal the threads leaving the first two threads free of
sealant. This is to prevent loose material from accidently getting trapped in the line where
it could clog the valves.
Connect the regulator - note the direction of gas flow is marked. If installed backwards it
will not work.
Attach your Flexline from the house gas supply.
Leak test all connections.
WARNING
Regulators set for Natural Gas and LP (Liquid Propane) are NOT interchangable.
Use ONLY the regulator supplied with your XO.
NEVER connect to an unregulated gas supply.
Always use a professional to connect to your natural gas supply.
Always turn valve OFF when not in use.
Failure to follow the above information exactly may cause fire, explosion, serious
injury or death.
using natural gas
!
!
HOW TO LEAK TEST
Make a soapy water solution: 1 part liquid dish soap to 3 parts water
Make certain all control knobs are in the OFF position
Using a brush or spray, apply the soapy mixture to all connections.
Check for bubbles which indicate a leak.
NEVER test for a gas leak using an open flame.
16
To Next Page
Loading...
General