Connect and tighten the swivel nut of the gas hose to the griddle manifold connection
located at the right, rear of the unit. The connection must angle down, away from
the griddle to keep the gas line away from the heat generated during use.
CONNECTING THE TANK TO THE REGULATOR
Turn all control knobs to the OFF position.
Inspect the valve connection port, regulator and hose
for damage or debris.
Remove any debris - NEVER use damaged equipment.
Connect the regulator assembly to the tank valve and
hand tighten the nut clockwise to a full stop.
DO NOT over tighten or use wrenches. It can damage
the quick Coupling and cause a leak and/or fire hazard.
Open the tank valve slowly a full turn (counter-clockwise)
and use a soapy water solution to check for leaks before
attempting to light the griddle.
If a leak is found, close the tank valve and do not use your griddle until the leak is
repaired.
HOW TO LEAK TEST
Make a soapy water solution: 1 part liquid dish soap to 3 parts water
Make certain all control knobs are in the OFF position
Using a brush or spray, apply the soapy mixture to all connections.
Check for bubbles which indicate a leak.
NEVER test for a gas leak using an open flame.
PRIOR TO THE FIRST USE AND EVERYTIME YOU CHANGE YOUR LP TANK YOU
MUST CHECK FOR LEAKS.
gas connections - lp (propane)
WARNING
NEVER connect any outdoor appliance to an unregulated gas supply.
NEVER attempt to use any outdoor appliance if you smell gas
19
To Next Page
Loading...
General