To switch o the Dēus
Hold down Power for two seconds on the remote control.
Press left- and right-hand buttons simultaneously on the headphones.
-
YES
NO
After charging your device. (pg 29)
Switch on
the remote control
(after extending stems and holding the coil
away from the ground and any metal)
Switch on
the headphones
Validate or not the use
of the loudspeaker
Do not switch the Dēus on when the coil is near metal, inside a car, or when the stem is collapsed,
as this may interfere with calibration and lead to abnormal performance. If this should occur, switch
o and move away from any metal masses before switching it on again. Nevertheless, this does not
represent any risk to the equipment or its electronics. But may give abnormal results !
By default you begin by using the 1 - BASIC
factory program which is suitable for general use.
If you wish to test one of the 10 other factory programs,
simply scroll through them with
The LED on the coil gives 20 long, successive ashes to indicate that it is waking
up and recalibrating.
Once recalibration is complete, the coil becomes operational and its LED ashes
every second.
To Next Page
Loading...
Need help?
General
