English - 12
PROBLEM POSSIBLE CAUSE SOLUTION
Electric duster
does not start
No electricity. Check for power supply.
The power cord is not properly
plugged in.
Remove and reconnect the power
cord.
Unit runs but
the speed is
abnormal
Air inlet or air outlet is blocked. Remove blockage and clean the
filter or nozzle attachment.
Noise This product uses a high RPM
motor to provide powerful airflow
and could create a certain level of
noise. This is a normal sound.
Use a wider opening nozzle
attachment, switch to the lower
speed setting or operate in a
outdoor place.
Air inlet or air outlet is blocked Remove blockage and clean the
filter or nozzle attachment.
Abnormal
Temperature
of the airflow
or housing
This product generates powerful
motor heated air. After a
prolonged use, the airflow and
the machine surface might reach
a high temperature.
Stop using for at least one hour
until fully cooled down. Clean the
filter and check if the air inlet or
outlet is blocked. Use a glove the
isolate the heat coming from the
housing.
Sparks Occasion small amount of sparks
generated by the motor during
normal operation.
This is normal. Use nozzle
attachments to arrest most of the
occasion sparks along use.
Unit works with continuous
sparks.
Stop using for at least one hour
until the unit cools down. Clean
the filter and check if the air inlet
or outlet is blocked. Then point
to a safe area and turn on the
machine for 5 minutes. Spark
should disappear.
Nozzle falls off The nozzle is not properly
installed.
Follow the installation guide.
Fasten the nozzle before use.
(See Page 3: Special Instructions)
If troubleshooting does not resolve your problem, please contact XPOWER or other parties
authorized by XPOWER for further instructions.
Troubleshooting Guide
To Next Page
Loading...
Need help?
General
