English - 10
Installation and Operation Guide
Start Your Job
(Continued)
Before Turning on the Pet Dryer:
Please hold the hose tightly and point the nozzle outlet to a safe area.
Force Drying Stage
• In this stage, pets have been bathed and are saturated with heavy water. High-pressure
airflow can remove the heavy water efficiently.
• You can achieve high-pressure air by installing the cone nozzle or flat nozzle and dry at
the highest speed setting of the machine.
Table/Finish Stage
• In this stage, most of the heavy water on the pets have been removed in the force
drying stage, but there is still some moisture. Heated-temperature and high-volume
soft airflow can help to vaporize the rest of the moisture or to fluff and style.
• For model B-24, you can achieve high temperature airflow by using the heating
element. For other models, turn to the highest speed setting for around 10 minutes for
motor-heated airflow.
• To achieve high-volume soft airflow, switch to round nozzle and reduce the speed of
the machine.
Nozzle Selections
• The cone nozzle is used for the force drying stage when the concentrated airflow with
high pressure is needed.
• The flat nozzle is used for long coated (such as silky coat and natural long hair) pets to
prevent knotting in the drying process.
• The round nozzle allows higher volume and softer airflow with less noise for smaller
pets, sensitive areas or finishing and styling drying process.
Tips
• For pets that are sensitive to noise, try
to start with the lowest speed setting
and round nozzle. Then apply desired
speed and other nozzles gradually.
• Hold the nozzle adapter to avoid the
hot areas of the hose.
Nozzle
Adapter
To Next Page
Loading...
Need help?
General
