English - 14
Troubleshooting Guide
If troubleshooting does not resolve your problem, please contact XPOWER or other
parties authorized by XPOWER for further instructions.
PROBLEM POSSIBLE CAUSE SOLUTION
Pet Dryer does not
start
No electricity. Check for power supply.
The power cord is not properly
plugged in.
Remove and reconnect the
power cord.
The circuit breaker of the
power socket or power circuit
jumps.
Disconnect the Pet Dryer to
the power socket. Reset the
circuit breaker and reconnect.
The thermal switch is triggered. Turn off and unplug the
machine. Clean or replace
the filters. Plug and use again
after the machine totally cools
down.
Unit runs but the
speed / noise is
abnormal
Air inlet or air outlet is blocked. Remove blockage, clean or
replace the filters.
Carbon brushes of the motor
are worn out.
Contact XPOWER for more
assistance.
Leakage on the hose. Try to fix the leakage or
replace the hose. (See Page
12: Hose Maintenance)
Unit runs but the
machine gets very
hot
The motor produces heat and
heats up the machine after a
long time use.
Turn off the machine. Use
again after the machine
totally cools down.
To Next Page
Loading...
Need help?
General
