by
975-0265-01-01 1
PowerSource 400 Owner’s Guide
About Xantrex
Xantrex Technology Inc. is a world-leading supplier of advanced power
electronics and controls with products from 50 watt mobile units to one MW
utility-scale systems for wind, solar, batteries, fuel cells, microturbines, and
backup power applications in both grid-connected and stand-alone systems.
Xantrex products include inverters, battery chargers, programmable power
supplies, and variable speed drives that convert, supply, control, clean, and
distribute electrical power.
Trademarks
XPower PowerSource 400 is a trademark of Xantrex International. Xantrex is a
registered trademark of Xantrex International.
Other trademarks, registered trademarks, and product names are the property of
their respective owners and are used herein for identification purposes only.
Notice of Copyright
XPower PowerSource 400 Owner’s Guide © January 2006 Xantrex
International. All rights reserved.
Disclaimer
UNLESS SPECIFICALLY AGREED TO IN WRITING, XANTREX
TECHNOLOGY INC. (“XANTREX”)
(a) MAKES NO WARRANTY AS TO THE ACCURACY, SUFFICIENCY OR
SUITABILITY OF ANY TECHNICAL OR OTHER INFORMATION
PROVIDED IN ITS MANUALS OR OTHER DOCUMENTATION.
(b) ASSUMES NO RESPONSIBILITY OR LIABILITY FOR LOSS OR
DAMAGE, WHETHER DIRECT, INDIRECT, CONSEQUENTIAL OR
INCIDENTAL, WHICH MIGHT ARISE OUT OF THE USE OF SUCH
INFORMATION. THE USE OF ANY SUCH INFORMATION WILL BE
ENTIRELY AT THE USER’S RISK.
Date and Revision
January 2006 Revision C
Part Number and Product Number
975-0265-01-01, 852-0400
Contact Information
IMPORTANT SAFETY INSTRUCTIONS
Operating PowerSource 400 incorrectly or misusing it may damage the
equipment or create hazardous conditions for the user.
SAVE THESE INSTRUCTIONS—This manual contains important
instructions for PowerSource 400 that should be followed during installation and
operation.
Telephone: 1 360 925 5059 (direct)
Fax: 1 360 925 5143 (direct)
Email: customerservice@xantrex.com
Web: www.xantrex.com/support
Important:
Before using your PowerSource 400, be sure to read and save these
safety instructions.
WARNING: Shock hazard. Keep away from children.
PowerSource 400 generates the same potentially lethal AC power as a normal
household wall outlet.
• Do not insert foreign objects into the AC Outlet or the ventilation holes.
• Do not expose this product to water, rain, snow, or spray.
• Do not, under any circumstances, connect the unit to utility power AC
distribution wiring.
WARNING: Risk of injury or loss of life
Do not use PowerSource 400 in connection with life support systems or other
medical equipment or devices.
WARNING: Explosion hazard
Do not use this product where there are flammable fumes or gases.
WARNING:
Electric shock and energy hazard
Do not remove cover. No user serviceable parts inside. Refer servicing to
qualified service personnel.
WARNING: Shock and burn hazard
A battery can present a risk of electrical shock or burn from high short-circuit
current.
CAUTION: Risk of damage to the PowerSource 400
The unit will not work when connected to any AC load that has its neutral
conductor connected to ground. Such loads include AC distribution wiring and
house wiring.
To Next Page
Need help?
General