DIRTCARPET
BAG 00.9
BAG 00.9
17
3. REAR DRIVETRAIN
302665 COMPOSITE BALL JOINT 4.9mm - CLOSED WITH HOLE (4)
303123 ALU SHIM 3x6x2.0mm (10)
306219 COMPOSITE SET OF SERVO SHIMS (4)
322612 ADJUSTABLE TURNBUCKLE 75mm M3 L/R - HUDY SPRING STEEL™ (2)
323044 COMPOSITE REAR ROLL CENTER HOLDER
323354-M COMPOSITE UPRIGHT REAR - UPPER POSITION - MEDIUM
323357-M COMPOSITE UPRIGHT REAR - LOWER POSITION - MEDIUM
323382 ALU REAR HUB PLATE FOR MULTI ADJ. UPRIGHT - 1-HOLE - 7075 T6
325313 DRIVE SHAFT 97mm WITH 2.5mm PIN - HUDY SPRING STEEL™
325340 REAR DRIVE AXLE LB - HUDY SPRING STEEL™
327321 REAR ARM PIVOT PIN (2)
362280 ALU CONICAL SHIM 3x6x2.0mm (10)
362316 ECCENTRIC BUSHING SET - OPEN (2)
BAG
362651 BALL END 4.9mm WITH THREAD 8mm (2)
365230 DRIVE SHAFT COUPLING - HUDY SPRING STEEL™
365360 ALU WHEEL HUB 12mm - OFFSET “+3.0mm” (2)
902205 HEX SCREW SH M2x5 (10)
902254 HEX SCREW SH M2.5x4 (10)
902312 HEX SCREW SH M3x12 (10)
902316 HEX SCREW SH M3x16 (10)
940513 BALL-BEARING 5x12x4 RUBBER SEALED - GREASE (2)
941014 BALL-BEARING 10x15x4 RUBBER SEALED - GREASE (2)
962030 WASHER S 3x6x0.3 (10)
962031 WASHER S 3x6x0.1 (10)
980210 PIN 2x9.8 (10)
OPTIONAL HEX HUB EFFECTS
Different offset hex hubs are used to increase or
decrease the track-width.
LESS OFFSET
Rear - more traction
Front - more steering
MORE OFFSET
Rear - less traction
Front - less steering
WHEEL HUBS 12MM
#365360 +4.5mm - 6 SLOTS INCLUDED
#365359 +3.75mm - 5 SLOTS OPTION
#365358 +3.0mm - 4 SLOTS OPTION
#365357 +2.25mm - 3 SLOTS OPTION
#365356 +1.5mm - 2 SLOTS OPTION
#365355 +0.75mm - 1 SLOT OPTION
#365353 0mm - 0 SLOTS OPTION
#365354 -0.75mm - Lightw. OPTION
#365361 -1.25mm - Lightw. OPTION
REAR ROLL CENTER HOLDERS
#323044 HARD INCLUDED
#323044-G GRAPHITE OPTION
#323043 ALU OPTION
#325341 REAR ADJ. DRIVE AXLE LB - HUDY SPRING STEEL™
#
325390 ALU SHIM 10x12x2mm (2)
HUDY TITAN BALL ENDS
#990006 6mm LONG OPTION
#990008 8mm LONG OPTION
303123
327321
962030
962031
325313
97mm
362316
362316
902205
902312
940513
941014
362280
362651
362280
362651
902316
980210
902254
902254
323382
322612
302665
302665
306219
323044
980210
325340
365230
(Lower Position)
REAR UPRIGHTS
#323354-M MEDIUM UPPER INCLUDED
#323357-M MEDIUM LOWER INCLUDED
#323354-H HARD UPPER OPTION
#323354-G GRAPHITE UPPER OPTION
#323357-G GRAPHITE LOWER OPTION
#323355 ALU HIGH UPPER OPTION
#323356 ALU LOW LOWER OPTION
Position
(6 Slots)
(Upper Position)
323354-M
323357-M
365360
#305231
DRIVE SHAFT COUPLING HUDY
SPRING STEEL
XRAY BALL-BEARINGS
#940512 5x12x4 OIL OPTION
#941015 10x15x4 OIL OPTION
#940513 5x12x4 GREASE INCLUDED
#941014 10x15x4 GREASE INCLUDED
To Next Page
Loading...