DIRTCARPET
GEARING CHART
SPUR
GEAR
PINION
MIN.
PINION
MAX.
69T
27T 43T
72T 24T 40T
75T 21T 37T
78T 18T 34T
81T 15T 31T
GEAR
RATIO
Final Drive Ratio
(Spur) (Pinion) (IGR)
78
:
X
x
2.65
= FDR
PINIONS (48P)
#294017 17T
#305918 18T
#294019 19T
#294020 20T
#294021 21T
#294022 22T
#294023 23T
#294024 24T
#305925 25T
#365726 26T
#365727 27T
#365728 28T
#365729 29T
#365730 30T
#365731 31T
#365732 32T
#365733 33T
#365734 34T
#365735 35T
#365736 36T
#365737 37T
#365738 38T
36
7. FINAL ASSEMBLY
902306
SH M3x6
NOTE
ORIENTATION
Pinion & Set screw
(NOT INCLUDED)
2x
#107875
DOUBLE-SIDED TAPE
Receiver
(NOT INCLUDED)
FRONT POSITION
REAR POSITION
Speed Controller
(NOT INCLUDED)
#107876
HUDY ULTRA THIN DOUBLE-SIDED TAPE - SINGLE STRIP (5)
#326153
STAINLESS STEEL WEIGHT UNDER SERVO FOR 1-PIECE CHASSIS 13g
#326149
GRAPHITE PLATE FOR ELECTRONICS FOR 1-PIECE CHASSIS - SET
#326152
STAINLESS STEEL WEIGHT FOR ELECTRONICS 1-PIECE CHASSIS 30g
(Including 2pcs Hex screws 110° SFH M2x3 #913203)
(Including 4pcs Hex screws 110° SFH M2x3 #913203)
(Including 4pcs Hex screws 110° SFH M2x3 #913203)
CHASSIS TUNING
GEAR MESH
Adjust the motor so the pinion meshes with
the spur gear properly. Make sure the gear
mesh is NOT too tight.
There should be a small amount of play
between the teeth of the pinion gear and
the spur gear.
3x6mm
Motor
(NOT INCLUDED)
To Next Page
Loading...