DIFFERENTIAL OIL
Fill differential up to the
top of the diff pin.
DO NOT fill the diff to the
top of the housing.
TO ENSURE YOU HAVE THE SAME AMOUNT OF OIL FROM REBUILD TO REBUILD, DO THE FOLLOWING:
➊
Put the diff (without oil) on the scale and check the
weight (approximately 17.00g)
➋
Slowly pour oil into the diff and watch the weight. Add
1.30g of oil into the diff. The approximate weight of the diff
including oil is 18.30g.
LOW-MEDIUM TRACTION 5.000cSt (HUDY #106450)
MEDIUM-HIGH TRACTION 15.000cSt (HUDY #106515)
NOTE: Softer oil increases rear traction, harder oil increases on-power steering.
TIPS FOR REAR DIFFERENTIAL
17.00g + 1.30g = 18.30g
#107865
HUDY Professional Digital Pocket Scale 300g/0.01g
#107866
HUDY Professional Digital Pocket Scale 3000g/0.1g
10.000cSt
g
1 8.30
g
17.00
7
2.5x8mm
1. GEAR DIFFERENTIAL
964031
S 3.5x10x0.2
902258
SH M2.5x8
941014
BB 10x15x4
Rear diff
Silicone oil 10.000cSt
Fill just above the diff pin.
USE PROPER AMOUNT OF OIL IN THE DIFFS
Use a digital scale to measure the exact amount
of oil in the diff. Remember that during operation
the diff gets hotter and the heat may allow the oil
to expand. If there is too much oil inside it may
interfere with the diff operation and damage the
internal gears.
OIL
Install the screws equally but DO NOT
tighten them completely.
Finish tightening in this order.
➊
➋
➌
➍
HUDY ULTIMATE SILICONE OILS
#106440 4.000cSt - 50ml OPTION
#106450 5.000cSt - 50ml OPTION
#106460 6.000cSt - 50ml OPTION
#106470 7.000cSt - 50ml OPTION
#106480 8.000cSt - 50ml OPTION
#106490 9.000cSt - 50ml OPTION
#106510 10.000cSt - 50ml INCLUDED
#106492 11.000cSt - 50ml OPTION
#106512 12.000cSt - 50ml OPTION
#106513 13.000cSt - 50ml OPTION
#106515 15.000cSt - 50ml OPTION
#106520 20.000cSt - 50ml OPTION
#106530 30.000cSt - 50ml OPTION
#106540 40.000cSt - 50ml OPTION
#106550 50.000cSt - 50ml OPTION
#106560 60.000cSt - 50ml OPTION
#106580 80.000cSt - 50ml OPTION
CARPET
Use HUDY Ball-Bearing Grease
#106220 - STANDARD
#106221 - BLUE
#106222 - RED
4x
4x
2x