XTC Turn Signal System - User Manual

Honda Turn Signal System
Thank you for purchasing XTC Power Products Automatic Self-Canceling Turn Signal System. Our Easy Install Turn Signal
System is unique from the other kits on the market. This kit is from our Plug & Play™ product line, with only connecting
power, ground and plugs into the OEM Tail Light Harness, utilizing the brake lights as Brake and Turn Signals.
Please read the instructions fully and familiarize yourself with the components before starting the install. Remember
that these are basic instruction and you can install in other locations if desired, so feel free to be creative. The only
two places that have to interface is at the Rear Wire Harness and at the AUX Power Port next to the Power Steering.
NOTE: When installing make sure that wires are run away from any hot or moving parts and properly secured.
1. Remove the hood and the dash cover by removing 9 Allen Screws, this gives access to inside the Dash

Summary

Honda Turn Signal System Installation

System Introduction and Overview

Overview of the XTC Power Products Automatic Self-Canceling Turn Signal System, highlighting its unique features.

Component Diagram

Diagram illustrating the Honda Talon Plug & Play Automatic Self-Canceling Turn Signal System components.

Step 1: Accessing the Dash

Remove the hood and dash cover by unscrewing 9 Allen screws to gain access to the dash.

Step 2: Mounting the Control Module

Mount the Control Module under the hood using a self-tapping screw or cable ties, securing it away from hot parts.

Step 3: Connecting the Rear Harness

Unplug the 6-Way Connector near the air cleaner and plug the rear harness in-line.

Step 4: Routing and Connecting the 4-Pin Harness

Route the 4-pin connector from the 6-way plug to the Control Module, securing it to the OEM harness.

Step 5: Installing Front LED Turn Lights

Mount front LED turn indicators, drilling 5/8" or 1/4" holes as needed for grommet use.

Step 6: Installing Switches and Applying Dielectric Grease

Install Turn and Hazard-Horn switches, using Dielectric Grease on terminals for corrosion resistance.

Step 7: Installing the Hazard Horn Switch

Use the provided template to cut and install the Hazard Horn Switch into the dash.

Step 8: Connecting the Power Harness

Unplug the blue connector near the power steering unit and plug in the ATS Power Harness.

Step 9: Mounting the Horn

Mount the horn under a forward dash cover Torx screw and connect the violet and black wires.

Step 10: Verification and Finalizing Installation

Verify all lights operate correctly, secure cables with ties, and reinstall vehicle parts.

System Operation and Features

Details on momentary switch activation, self-canceling times for different turns, and hazard light operation.

Optional Dash Indicator

Information on using the Tan wire for an optional dash-mounted LED indicator light.

XTC Turn Signal System Specifications

General

Brand	XTC
Model	Turn Signal System
Category	Automobile Electronics
Language	English