Xtool S1 - Example Projects; Understand the Annular Indicator

Example projects
Understand the annular indicator
Buzzer
Machine state
Solid white
/
Buzzing for 3 seconds
Buzzing for once
Standby
Auto focusing
Framing
Locating the material
Performing a task
Ready for framing
Task paused
Ready to work
Exceptions occur
Flame detected
Firmware updating
Network setting
(device disconnected from
the software)
Standby, connected to the
software via Wi-Fi
Measuring curved surface
TF card exceptions occur
Exceptions occur on
movement
The lid is not fully closed
during operation.
Exceptions occur on Wi-Fi
communication
Starting
/
Short press to stop the warning
/
/
/
/
Long press to cancel auto focus
/
/
/
Long press to set the network
Long press to cancel curved surface
measurement
Short press to pause the processing;
long press to cancel the processing
Short press to mark a vertex;
long press to cancel material locating
Short press to start framing;
long press to cancel framing
Short press to start the processing;
long press to cancel the processing
Short press to continue the processing;
long press to cancel the processing
Short press to stop the warning
Short press to stop the warning
Keeping buzzing
Blinking purple
Solid purple
Blinking white
slowly
Blinking green
slowly
Blinking purple
slowly
Blinking yellow for
3 times
Solid blue
Solid blue
Blinking blue slowly
Blinking red
Blinking red
Blinking red
Blinking yellow
Blinking yellow
Button operation
Annular indicator
xTool S1 is delivered
with a material pack
that allows you to
start your creation.
Scan the QR code to find example projects and tutorials.
Alternatively, you can visit https://support.xtool.com/product/24 and go to Try Some Projects to view
example projects and tutorials.
https://support.xtool.com/article/1328
08