Alarm management
• Each detector can trigger 2 Alarm outputs
• Alarm 1: Alarm in main zone, creep zone (zone 1 or S/M/L)
• Alarm 2: Battery level low, needs to be replaced
• Alarm 1&2: Any kind of tamper alarm
• A 120 seconds absence of any kind of message from the detector
(caused by its destruction, jamming, completely depleted batteries, etc.)
will trigger an additional Alarm on the associated receiving panel = >
Inactivity
• Thus, *three* outputs per detector are needed to communicate all
events from and about a detector to a connected Fasttrace (or any
other kind of alarm management device)
To Next Page
Loading...
