18
HELP
Propellers are spinning, but the Drone will not lift off the ground.
• Check the propellers for any sign of damage. Bent or broken propellers should be replaced promptly with the spare propellers included
in your package.
• The Drone battery has insufficient power. Make sure the Drone battery has been fully recharged.
The Drone keeps drifting in a certain direction during flight even in calm wind conditions.
• Check for trapped dirt around the motors driving the propellers. Just a little strand of hair could make the Drone difficult to control.
• Adjust the trim to compensate for the drifting. Repeatedly push the appropriate trim adjuster opposite to the direction the Drone is
drifting towards until drifting stops. For example, if the Drone drifts forward, push the Forward/Backward Trim adjuster down, and vice-
versa. If the Drone drifts to the left, push the Sideway Trim adjuster to the right, and vice-versa. If the Drone spins counter-clockwise,
push the Rotation Trim adjuster to the right, and vice-versa.
• Recalibrate the gyro sensor after a heavy landing. First, place the Drone on a flat, level surface, and then hold both control sticks to the
lower left corner until the status lights on the Drone blink rapidly. When the lights turn solid, the calibration process is complete.
The Drone responds slowly and does not maintain altitude easily.
• Battery voltage (power) is running low. Before power to the motors is cut off entirely, gradually lower the throttle stick until the Drone
descends and lands safely, and immediately charge the battery.
• The Drone has flown outside of the range of the controller. Bring the Drone closer to your position.
Video recording is not smooth. Horizontal lines intermitently appear.
• Signal interference with other 2.4GHz devices in the vicinity of the Drone may cause horizontal lines to appear in the video recording.
The lines may also appear when the camera is in challenging lighting conditions such being exposed to bright light and dark shadows
simultaneously.
• If your GoPro
®
camera is mounted to the Drone with the included GoPro
®
bracket, try changing your GoPro
®
video resolution setting to
60fps to reduce any rolling shutter effect in the video recording.
The controller is blinking and beeping continuously.
• Batteries need replacing. Insert a new set of AA batteries into the controller.
To Next Page
Loading...
