Xtrem Bots Trooper Bot - Page 6

6
3. batteries installation
in the transmitter
in the robot
Robot ba ery is into the back of the Trooper Bot.
To charge ba ery, please insert the USB port provided USB charging cable to anyone USB port of a
computer, a power pack, a mobile charger or a car USB charger.
Switch OFF the robot before charging. A light in the robot will be turned on during the chargins process;
when the robot is fully charged the light will turn o .
The charging  me is about 2 hours and the playing  me is about 2 hours.
4. start the Trooper Bot
Switch on the ON/OFF bu on on the back of the Trooper Bot and
push the “StandBy” bu on to start the Trooper Bot. The Trooper Bot
introduce himself performing some movements and sounds.
NOTE: The robot should stay on the  oor.
1. Use a philips’ head screw to open the bu on cell gate of controller.
2. Put 2 x 1.5V “AA” ba eries inside the ba ery box.
3. Put the gate back and use a screw to  ghten the gate.