Xtreme Polishing Systems Mammoth800 User Manual (English)

Questions and Answers:

R
rhondariveraSep 8, 2025
Why is my Xtreme Polishing Systems Grinder dithering during operation?
- E
  edominguezSep 8, 2025
  If your Xtreme Polishing Systems Grinder experiences a dithering phenomenon during operation, consider: * **Move wheel and grinding plates not parallel:** Adjust the move wheel bolt to ensure the move wheel keeps the same force on a flat surface. * **Grinding plates not level:** Adjust the grinding plates fixed bolt to ensure all three grinding plates are on the same level surface. * **Unmatched or different height abrasive tools:** Replace with abrasive tools of the same specification and height. * **Loose gear box fixed bolt:** Tighten the gear box fixed bolt to keep it in a proper situation.
R
Richard BartlettSep 10, 2025
What causes oil leakage on the grinding plate drive shaft of my Xtreme Polishing Systems Mammoth800 Grinder?
- D
  danny09Sep 10, 2025
  If you observe oil leakage or impregnation on the grinding plate drive shaft of your Xtreme Polishing Systems Grinder: * **Broken bearing:** Replace the bearing. * **Aging sealing part:** Replace the sealing part. * **Debris twisted drive shaft:** Maintain the machine and repair any damaged parts caused by debris.
E
Eric WrightSep 12, 2025
Why do the abrasives on my Xtreme Polishing Systems Mammoth800 Grinder wear unevenly?
- S
  Seth Rogers Jr.Sep 12, 2025
  If you notice different wear intensity of abrasives on your Xtreme Polishing Systems Grinder: * **Aging or broken rubber cushion:** Replace the rubber cushion. * **Grinding head plates not level:** Adjust the holding bolts to make sure the grinding plates are on the same level surface. * **Broken spring cushion:** Replace the spring cushion.
D
david33Sep 13, 2025
Why is the power supply light not working on my Xtreme Polishing Systems Grinder?
- M
  melissa18Sep 13, 2025
  If the power supply indication light on your Xtreme Polishing Systems Grinder is not working or blinking: * **Broken indicator light:** Replace the indicator light. * **Loose wire connection terminal:** Tighten the wire connection terminal. * **Unstable input voltage:** Adjust to a stable input voltage. * **Loose wiring terminals:** Fasten wiring terminals and ensure the connection point is in good condition.
J
Jeremy VanceSep 15, 2025
Why is the grinding plate pressure light blinking on my Xtreme Polishing Systems Mammoth800 Grinder?