ASSEMBLY
The machine has been thoroughly inspected and partly assembled before shipment.
Please take the time to nish assembly by following the steps below.
Step 1: Attach the rear foot
Step 2: Attach the front foot
Step 3: Attach the front post
Step 4: Attach the armrest console
Step 5: Connect the wires
Step 1: Attach the rear foot to the rear of the curved track. Remove the 2 bolts which
have been pre-attached to the rear foot, then re-attach the bolts to connect the
foot to the track. Finger tighten the bolts only. DO NOT tighten the bolts with a tool
until the unit is fully assembled.
3
To Next Page
Loading...
