•
Feed down the machine in line with the blade. Pressure from the side can damage the blade and is
very dangerous.
OP
E
R
A
TION
/ MA
INT
E
N
A
N
CE
1. Inspection of the diamond wheel
A worn diamond wheel overloads the motor and reduces working efficiency. Replace it with a new one.
2. Inspecting the mounting screws
Regularly inspect all mounting screws and ensure that they are property tightened Should any of the
screw's be lose, retighten them immediately. Failure to do so can result in serious injury.
3. Maintenance of the motor
Exercise due care to ensure the winding does not become damaged and/or wet with oil or water.
4. Keep tool clean and free from debris
Avoid using cleaning products, which include benzene. trichloroethane, chloride, or ammonia as these
can damage plastic parts.
5. In case of electrical or mechanical malfunction. Immediately switch off the tool and disconnect the
plug.
6. For all other service take machine contact us at info@starktoolsusa.com
M
AINT
E
NANC
E
8
To Next Page
Loading...