This variable speed pump is designed to operate your swimming pool filtration system as well
as your
spa, waterfall, cleaner, heater, salt chlorine system and other water applications.
Using the control panel, you can run your pump on one of three scheduled programs:
1.
Regular mode:
use three quick start buttons.
ECO (default 1500RPM) /CLEAN (default 2400RPM) /BOOST ( default 3250RPM), and then
adjust
the pump to run at the speeds you selected.
2.
Mode 1:
16 hours for each clean cycle.
3.
Mode 2:
24 hours for each clean cycle.
The control panel also has LED indicators for speed as well as alarm indicators and e rror
messages to warn the user against under and over voltage, high temperature, over current
and freeze protection.
1.
Features of LED Control Panel
(1)
Display and change time
(2)
Display and change running spe ed
(3)
Quick-start button of ECO/CLEAN/BOO
ST to run on different sp eed
(4)
MODE1/MODE2 for scheduled prog ram (16 hours or 24 hours c lean cycle)
(5)
Re-start and reset to normal s chedule after over cu rrent, over voltage, over heat, or
unexpected power o ff.
(6)
Keep records of scheduled p rograms for maximally 1 5 days after power off.
(7)
Password needed w hen to make change of the program. ( not effective now)
(8)
Run 5 minutes high speed when first start t he pump
(9)
Step-by-step acceleration and deceleration of the speed to extend the us e life of the
motor and control pan el
2
To Next Page
Loading...