COLLECTOR REPAIR
IF A COLLECTOR DEVELOPS A LEAK
If a leak develops for any other reason, you may us
e the repair method shown.
The collectors are not warranted against freeze damage.
SOLAR COLLECTOR REPAIR
This method allows for an easy and permanent, on-site repair of a collector by
isolating the leading riser tube. Referring to the figure at the right, locate the
tube to be isolated. (End tube has been shown for clarity). Using a sharp utility
knife, very carefully cut away approximately 1" of the tube at both headers.
Drive a #10 sheet metal screw, preferably stainless, into the hole in the header.
The screw must be between 1/2" and 3/4" long.
DO NOT OVERTIGHTEN! If the screw strips out, or if the repair leaks,
use a #12 screw. This repair method will not void the collector warranty.
With proper care and winterization, you will enjoy your solar collectors for many
years.
8
To Next Page
Loading...