- Sleep mode is on. Press the POWER button or touch the screen to release the
mode.
- The rear view camera image is displayed with no camera connection and the
wrong camera polarity setting. Install the rear view camera and then change the
camera polarity settings.
A black screen is displayed, and operation is not possible
- GPS positioning is disabled if signals cannot be received from more than two GPS
satellites.
- In some driving conditions, signals from GPS satellites may not reach your vehicle.
In this case, it is impossible for the system to use GPS positioning.
- If a car phone or cellular phone is used near the GPS antenna, GPS reception may
be lost temporarily.
GPS positioning is not possible
- The Bluetooth reception is poor. Move the mobile phone closer to the product or
remove any obstacle between the mobile phone and the product.
- Some mobile phones may connect and disconnect constantly when you make or
end calls. This does not indicate any malfunction of the product.
- For some mobile phones, the Bluetooth connection may be deactivated
automatically as a power-saving feature. This does not indicate any malfunction
of the product.
The paired mobile phone connects and disconnects constantly
- The antenna connection is incorrect. Check the antenna connection.
- Interference may be introduced. Check for sources of interference.
- Signals are too weak. An additional antenna signal amplifier booster may be
required.
- The antenna has been damaged. Replace the antenna.
- The local seek tuning has been turned off. Turn the local seek tuning on.
Poor radio reception
To Next Page
Loading...
Need help?
General
