Xylem OI Analytical 5383 - PFPD Assembly and Maintenance; PFPD Assembly Diagram; Recommended Tools and Consumables; Ferrules Warning

Model 5383 PFPD Assembly
Teflon
®
and Vespel
®
are registered trademarks of E.I. DuPont de Nemours, Inc.
Part number 330680
Publication 41700316
Detector cap
(246900)
Detector cap
mounting screws
(295287C)
Detector body
mounting screws
(295295C)
Detector body
(301333)
Combustor
(282939C, 2 mm
or 282913C, 3 mm)
Combustor sleeve
(283093C)
Large aluminum washer
(288050)
PMT signal cable
PMT HV cable
Heater cable (part number
depends on GC type)
Detector base
(301325)
Small aluminum crush washer
(288076)
Gas lines
Combustor support
(280461C, 2 mm
or 280453C, 3 mm)
Flame arrestor
(286393)
Ignitor assembly
(282624)
PMT housing
(286096)
OI Analytical recommends keeping the following tools and consumables on hand for quick and easy PFPD maintenance:
Item Units Part Number
Tested combustors 1 or 2 each 282939C, 2 mm
282913C, 3 mm
Large aluminum crush washers 1 pkg 288050 (pkg of 10)
Small aluminum crush washers 1 pkg 288076 (pkg of 10)
Ignitor assembly 1 each 282624
Cap-to-body screws 2 each 295287C
Body-to-base screws 2 each 295295C
Fuse 2 each 298984
Column nut 1 each 223057
Combustor extraction tool 1 each 280719, 2 mm
280727, 3 mm
Teflon
®
-coated forceps 1 each 283051
Allen wrench 1 each 284539
Column positioning tool 1 each 318949
Flow adaptor 1 each 202077
WARNING: Do not use graphite ferrules. Only use graphite/Vespel
®
ferrules to avoid graphite pieces contaminating the detector combustor.
PMT cap