T10/T20/T30/T40 User Manual
This is a three-time controller into the evening (evening) working time, an interval of rest or
pause time, Dawn working time (morning light function), the user can according to their
needs, set a different time.
This is a compatible MPPT charge controller PWM intelligent / efficient / energy saving, he
not only has efficient MPPT controller charging function to automatically track the
maximum power point, 10% -30% higher than the ordinary controller charging efficiency,
also has standby energy saving, more than 30% energy than ordinary controller, the
standby power consumption of only 10mA-15mA.
1:Product introduction
"T" series of an intelligent, multi purpose solar charge controller
LCD screen display Battery reverse discharge protection
Simple (and more time control) operation Battery reverse polarity protection
MPPT+ PWM charging mode Battery under voltage protection
Parameter user can reset Overload, short-circuit protection
A key to open and close the load
Automatic temperature compensation
function
A key to restore the factory settings USB5V charge (current 500mA) Optional
2: Installation Instructions
Installation（Installing wires, first loosen the screw counterclockwise）
1 Ready installation tools and materials, and cable. Please
2 ensure that the current density <4A/mm2 This will help reduce the
Check the installation site meets the relevant safety requirements, avoid damp,
dusty, flammable, explosive and corrosive gases
3 Install the controller fixed to the vertical plane, see Section V mounting aperture and
hole spacing. In order to ensure a good controller cooling conditions, the controller
on the bottom of each reserved 10cm space
4 As shown on the right wiring sequence: load, battery, solar
Battery plate is connected to the controller to be taken to ensure that the load,
battery,
The polarity of the solar cell panel and controller
To Next Page
Need help?
General