T10/T20/T30/T40 User Manual
This is a three-time controller into the evening (evening) working time, an interval of rest or
pause time, Dawn working time (morning light function), the user can according to their
needs, set a different time.
This is a compatible MPPT charge controller PWM intelligent / efficient / energy saving, he
not only has efficient MPPT controller charging function to automatically track the
maximum power point, 10% -30% higher than the ordinary controller charging efficiency,
also has standby energy saving, more than 30% energy than ordinary controller, the
standby power consumption of only 10mA-15mA.
1:Product introduction
"T" series of an intelligent, multi purpose solar charge controller
LCD screen display Battery reverse discharge protection
Simple (and more time control) operation Battery reverse polarity protection
MPPT+ PWM charging mode Battery under voltage protection
Parameter user can reset Overload, short-circuit protection
A key to open and close the load
Automatic temperature compensation
function
A key to restore the factory settings USB5V charge (current 500mA) Optional
2: Installation Instructions
Installation（Installing wires, first loosen the screw counterclockwise）
1 Ready installation tools and materials, and cable. Please
2 ensure that the current density <4A/mm2 This will help reduce the
Check the installation site meets the relevant safety requirements, avoid damp,
dusty, flammable, explosive and corrosive gases
3 Install the controller fixed to the vertical plane, see Section V mounting aperture and
hole spacing. In order to ensure a good controller cooling conditions, the controller
on the bottom of each reserved 10cm space
4 As shown on the right wiring sequence: load, battery, solar
Battery plate is connected to the controller to be taken to ensure that the load,
battery,
The polarity of the solar cell panel and controller
To Next Page
General