Ya-man Medi Lift PLUS User Manual

12
Preparation
Charge the device
Before Use
Light
AC adapter*
* The picture presented here is
for an illustration purpose only.
Light
Controller (left)
Controller (right)
USB charging
cable
The light will blink red.
The light will go off. Unplug
the USB charging cable.
Approx. 2 hours (room
temperature approx. 25° C)
Approx. 4.5 hours
Charging
When charging
is complete
Charging time
Operating time
* Actual charging time and operating time will differ depending upon the
remaining power and the charging environment.
ATTENTION
If there is any water droplet on the controllers or charging terminal, make sure to wipe them dry before use.
Charging the device with water droplets on the device could cause a failure.
Be sure to attach the magnetic charging terminal in the correct direction. Charging will not begin if the magnetic charging terminal is attached in a
wrong direction.
Fully charge the battery before using the device for the first time.
When using the device for the first time or when the device has not been used for an extended period of time, it is possible that you will be able to
use the device for a short time only, even with a full charge. In such a case, charge the controllers again before using it.
Use only the included AC adapter. In some cases, the unit might not charge properly if using a generic AC adapter.

Ya-man Medi Lift PLUS Specifications

General

Technology	EMS (Electrical Muscle Stimulation)
Power Source	Rechargeable Battery
Waterproof	No
Adjustable Intensity Levels	Yes
Hands-free Operation	Yes
Treatment Time	10 minutes
Battery	Lithium-ion
Charging Time	Approx. 2 hours
Target Area	Face
Functions	EMS
Intensity Levels	6