Yaber U2 - STARTING PROJECTOR; Powering On the Projector; Powering Off the Projector

aftersales@yabertech.com
STARTING PROJECTOR
Turn on the projector
1.Install two AAA batteries in the remote control before using.
2.Remove the lens cover of the projector.
3.Press the Power key on the remote controller or panel, the indicator light
tum off from Red..
4.The lamp will start working, 2 seconds later, when an image is projected
on the screen, the machine is working smoothly. If the first projection
screen is not the start up screen, press the "S" button on the remote
controller and select Media source.
5.Adjust the keystone ring to get a rectangle shape.
6.Adjust the focus ring or rotate the lens of the projector to get the best image
performance. ((f it is still blurry, please try to adjust the projection distance.)
7.If you connect other devices, be sure to select the corresponding source. If
you do not select the correct source, the projector will not be able to detect the
signal.
8Press the Menu button on the remote control to enter [Setup] option - OSD
Language to set your preferred language.
Turn off the projector
1.Press the Power bution when the projector is in use, this will cause it to
switch to standby mode.
2When the projector switch into standby mode, the light wil tum red.
09