Yaber V10 User Manual

upport@yabertech.com
Note:
1).Install 2 pieces of AAA batteries into the remote before using it. Do not
combine new batteries with old ones in remote controller, which can cause
operation failure due to insufficient power supply.
2)When using the remote controller, please make sure that the signal
transmitter of the remote controller aims at infrared signal receiver of the
projector.
3).If you are not using the remote controller for an extended period, please
take out batteries to prevent batteries leakage.
INSTALLATION
1. Installation Method
The projector can be hanged on the ceiling with special hanger frame, and
placed on the stable desk to project the image according to the operating
environment and requirements. In addition, the projector can be installed with
Adj ~ AAA
1.Front projection Ceiling mount | 2.Rear projection Ceiling mount
i == aaa
3.Front projection Table mount 4 Rear projection Table mount
Keep the projector at a height where its lens is axial symmetry to the screen.
If this is not possible, use the keystone correction function to adjust the
projection image.
If you want to get a free projection screen,please contact us via
Support@yabertech.com
06

Yaber V10 Specifications

General

Display Technology	LCD
Resolution	1920 x 1080
Brightness	9500 lumens
Contrast Ratio	10000:1
Lamp Life	100, 000 hours
WiFi	Yes
Bluetooth	Yes
Maximum Supported Resolution	4K
Keystone Correction	±50 degrees
Ports	HDMI, USB, AV, Audio Out
Projection Size	45-300 inch
Aspect Ratio	16:9
Speaker	3W
Weight	5.5 kg