Insert the jumper cable into the jump starter and connect the clamps to car battery.
(Red to “+”, Black to “-”).
The icon shows on the screen.
Start your car engine.
JUMP START YOUR CAR
About The Force Start Function
About The Troubleshooting
③②
1
2
3
3 steps to fix the problem:
If the screen doesn’t display any icons when you correctly connected the clamps to
your car battery, you can use the Force Start Function to enter boost mode.
①
*3s
③②
Press the force start button for more than 3 seconds.
The 2 icons show the screen.
Start your car engine.
1
2
3
Warning: When using the Force Start Function, auto-detection and safety protection
will be disabled.
LONG PRESS
Indicator Situations
EC5 Short circuit protection
--Automatically recover when the clamps disconnect
The relay in the host is stuck
--The car can still be started, but product protection is disabled. It is
not recommended to use it in non-emergency situations, and it is
recommended to contact customer service for the replacement
Reverse connection protection
--Reverse the clamps and ensure the correct connection
High temperature protection
--Automatically recover when the temperature drops
Low voltage protection
--Please charge the jump starter
High voltage protection
--This model is only for 12V engine, but the voltage of connected
car battery is far higher than 12V
EN01 02 03 04 05
06 07 08 09 10
11 12 13 14 15
16 17 18 19 20
21 22 23 24 25
26 27 28 29 30
To Next Page
