What to do if the Yacht Devices YDWG-02R Gateway LED doesn't signal when NMEA 2000 is on?
First, verify that the bus power is supplied, as the NMEA 2000 network needs its own power connection and can't rely on power from a plotter or other connected device. If that's not the issue, try cleaning the device connector with a spray designed for electrical contacts, and then plug the device into a different connector.
How to fix Yacht Devices Gateway when it cannot connect to Wi-Fi?
To resolve this, try rebooting the Gateway to disconnect all Wi-Fi connections. If the issue persists, switch applications from the TCP to the UDP protocol.
What to do if I cannot open the TCP server port of the Yacht Devices YDWG-02R in the application?
First, configure the application to use another server port or switch to UDP. If that doesn't work, ensure you can access the administration website with a browser; if not, reset the Gateway settings.
What to do if Yacht Devices YDWG-02R Gateway doesn't signal with a 5-second interval?
Reset the Gateway settings or perform a hardware reset.
Why is my software application not working as expected with the Yacht Devices YDWG-02R?
Check the NMEA filters configuration. You may also record diagnostics data and send it with a software screenshot to technical support.
How to troubleshoot login issues on the Yacht Devices YDWG-02R Wi-Fi network or administration website?
Reset the Gateway settings.
General| Category | Gateway |
|---|---|
| Manufacturer | Yacht Devices |
| Model | YDWG-02R |
| Connectivity | Wi-Fi, NMEA 2000 |
| Supported Protocols | NMEA 2000, NMEA 0183 |
| Wi-Fi Standards | 802.11 b/g/n |
| Power Supply | NMEA 2000 |
| Operating Voltage | 9-16 V DC |
| Current Consumption | 50mA |
| Waterproof | IP67 |
| NMEA 2000 LEN | 1 |
| Compatibility | NMEA 2000 |
| Interface | Wi-Fi |
Configures the Gateway to create its own Wi-Fi network.
How to control autopilot modes and settings via the gateway.
To Next Page
