What to do if the Yacht Devices YDNG-03 LED doesn't signal after powering on the NMEA 2000 network?
First, ensure that the NMEA 2000 network has a dedicated power supply, as it cannot be powered by devices like plotters. If the power supply is ok, try cleaning the device connector with a spray designed for electrical contacts, then plug the Yacht Devices Gateway into a different connector.
Why is the sixth flash red on my Yacht Devices Gateway (TX overflow)?
A red sixth flash indicates a TX overflow. If possible, increase the speed of the Gateway's port and the speed of the connected equipment.
Why is the third flash in the 6-flashes sequence (NMEA 0183 RX) always red on my Yacht Devices YDNG-03 Gateway?
Ensure that the Gateway port speed matches the equipment speed. Also, verify the connection schema and wire colors.
What to do if the first flash in the 6-flashes sequence (NMEA 2000 RX) is RED on my Yacht Devices Gateway?
Try cleaning the device connector with a spray for cleaning electrical contacts and plug the device into another connector. You can also plug another device into the selected connector to confirm it appears on the plotter's device list.
купил YDTA-01R,подал 24в. теперь не работает, его можно починить ?
Details the procedure for connecting the Gateway directly to the NMEA 2000 network backbone.
Sets the baud rate for the NMEA 0183 port, from 300 to 115200.
Configures filter types (WHITE/BLACK) for NMEA 0183 and NMEA 2000 data.
Defines lists of NMEA 0183 sentences to filter for transmission and reception.
Sets NMEA 2000 filters using PGNs and masks for message identification.
General| Brand | Yacht Devices |
|---|---|
| Model | YDNG-03 |
| Category | Gateway |
| Language | English |
To Next Page
