Control your alarm by SMS
SMS coMMand
Pin ALARM On/O
Pin CONFIGURE NewPin
AlarmNumber1
(AlarmNumber2)
Pin GPS (NEXT)
Pin OUT NotUsed/
On/O/Siren
Pin SHUTDOWN
Pin STATUS
PIN VOLTAGE TRIGGER
TriggLevel/O
deScription
Activate/Deactivate burglary and
intrusion alarm.
Congure the alarm unit with one or
two alarm receivers and possibly also a
new PIN code..
Read current GPS position with map
link. The parameter NEXT can be used
when there is poor GPS coverage, then
the alarm unit does not respond until a
new position is available.
Activate/deactivate output or use it as
a siren (only YachtSafe Boat Alarm).
The alarm unit shuts down after the
external power supply is disconnected.
Read status information like battery
voltage, etc.
Activate/Deactivate monitoring of the
external driving voltage. Trigger level
must be in steps of 0.1V (for example
110 = 11.0 volts).
SMS usage
Communicate with the alarm
Note that the alarm unit needs to be connected to a voltage
source. SMS commands are sent from a regular mobile phone
to the alarm’s phone number. All commands begin with the
alarm unit’s four-digit PIN, space, and then the name of the SMS
command.
For example: 1111 gps or 1111 status
All SMS commands are answered with an SMS from the alarm
device.
To Previous Page
