10
Initial Setup
Set the date & time before installing and using the Roadcam. This date &
time is the time stamp for all recorded media files and digital clock.
Switching Modes
Press the button to cycle through the following modes: video mode >
camera mode > playback mode. The Roadcam cannot switch between
modes while it is recording. Press the button to stop recording and
press the button to switch between modes.
Video Mode
• This is the default recording setting. The Roadcam will start recording
automatically once it is turned on.
•
Files are looped or recorded over by the default of 1 minute.
The MicroSD card will hold 1 minute segments and record over them as
space is needed.
•
Stop loop video: press the
button once to pause or resume recording.
• Lock video: press the
button during recording to lock that recorded file.
•
Press the button during recording to turn the microphone on or off.
Note: The Roadcam will not record automatically when you switch back
to video mode from other shooting modes. You need to press the
button manually to start recording.
CONFIGURATION & MENU SETTINGS
To Next Page
