To Next PageTo Next Page
Need help?Do you have a question about the Yaesu VX-3R and is the answer not in the manual?
General| Modulation | FM |
|---|---|
| Dimensions | 23 mm |
| Channel Capacity | 1000 channels |
| Receiver Sensitivity | 0.2 μV |
| Frequency Range RX | 0.5-999.99 MHz |
| Battery | FNB-82LI 3.7 V, 1100 mAh Li-Ion |
Explains the procedure for powering the transceiver on and off.
Guides on setting the squelch level to mute background noise and improve sensitivity.
Describes how to switch between the different frequency bands supported by the transceiver.
Explains methods for tuning frequencies using the dial and scanning features.
Covers the basic steps for transmitting, including power level adjustment.
Explains repeater shift directions and magnitudes for different bands.
Details the feature that automatically applies repeater shifts based on band sub-divisions.
Explains how to set and use CTCSS tones for repeater access and silent monitoring.
Details how to set and use Digital Coded Squelch (DCS) for enhanced tone access.
Covers the EPCS feature for selective calling and paging.
Covers storing, recalling, and managing standard memory channels.
Details how to recall stored memory channels.
Explains the function of Home channels for quick recall of favorite frequencies.
Covers organizing memories into banks for easier management.
Covers special memory channels like Weather Broadcast, VHF Marine, and Short-wave.
Explains how the scanner resumes after halting on a signal.
Details how to set the delay time before the scanner restarts.
Describes how to scan frequencies within the VFO mode with various bandwidths.
Details how to scan through memory channels using different modes like ALL CH, TAG, BAND.
Describes setting up a list of preferred channels for scanning.
Covers scanning within selected memory banks.
Describes scanning a priority channel while operating on another frequency.
Explains how to instantly switch to the priority channel.
Explains the emergency feature that activates the UHF Home channel for alerts.
Details the EAI feature for automatic callsign transmission during emergencies.
Guides on using EAI and other features to locate a missing person.
Settings for repeater shifts, bell ringers, and CTCSS/DCS/EPCS.
Settings for ARTS™ beep options, polling interval, and CW identifier.
Options for memory bank naming, display modes, and write protection.
Controls for scan modes, priority revert, and scan lamp.
Settings for power-off timers, busy indicators, battery savers, and wakeup features.
Restores all settings and memories to factory defaults.
Resets only the Set Mode items to their factory default values.
