To Next PageTo Next Page
Need help?Do you have a question about the Yaesu VX-170 and is the answer not in the manual?
General| Modulation | F3E (FM) |
|---|---|
| Channels | 200 |
| Channel Spacing | 12.5/25 kHz |
| Operating Temperature | -20°C to +60°C |
| Waterproof | IPX7 |
| Antenna | Detachable |
| Output Power | 5 W |
| Battery Life | 10 hours (with FNB-83) |
| Dimensions | 58 x 112 x 30 mm |
| Battery | FNB-83 (7.2V, 1400mAh NiMH) |
| Supply Voltage | 7.2 VDC (Nominal) |
Details on primary, secondary, and third functions of each keypad button.
Procedure for setting the squelch to minimize background noise.
Initiating manual and programmed VFO scans.
Basic steps for transmitting, including power levels.
Enabling ARS to automatically set repeater shifts based on sub-bands.
Setting independent transmit and receive frequencies in VFO mode.
Setting Tone Mode and Tone Frequency for CTCSS operation.
Setting Tone Mode to DCS and selecting a DCS code.
Scanning for CTCSS or DCS tones used by other stations.
Storing CTCSS tone pairs for EPCS Paging and selective calling.
Activating and disabling the Enhanced Paging & Code Squelch system.
Operating in a Split Tone configuration via the Set mode.
Procedure for storing frequencies and settings into memory channels.
Recalling stored memory channels and using the HOME channel.
Assigning and recalling memory channels within Memory Banks.
Choosing how the scanner resumes after halting on a signal (BUSY, HOLD, TIME).
Manual and Programmed VFO scanning procedures.
Initiating memory scanning and skipping channels.
Setting up a Preferential Scan List of selected memory channels.
Setting sub-band limits for scanning or VFO operation.
Operating on one channel while periodically checking another for activity.
Setting DCS codes and activating ARTS™ for range monitoring.
Storing and sending telephone numbers or access codes via DTMF Autodialer.
Storing 3-digit pager codes for DTMF Pager memory.
Activating and disabling the DTMF Pager feature.
Setting up and activating a password for unauthorized access.
Limiting maximum transmission time to conserve battery and prevent interference.
Settings for CTCSS, DCS, DTMF, and EPCS operations.
