Do you have a question about the Yaesu VX-177 and is the answer not in the manual?
Modulation | 16K0F3E |
---|---|
Mode | FM |
Channel Capacity | 200 Channels |
Number of Channels | 200 |
Operating Voltage | 7.4 V DC |
Deviation | ±5 kHz |
Spurious Radiation | Less than -60 dB |
Waterproof Rating | IPX7 |
Power Output | 5 W |
Channel Steps | 5/10/12.5/15/20/25/50 kHz |
Current Consumption (TX) | 1.6 A |
Modulation Type | FM |
AF Output | 500 mW (at 10% distortion) |
Receiver Sensitivity | 0.2 µV (12 dB SINAD) |
Receiver Selectivity | 12 kHz (-6 dB) |
Intermodulation | 70 dB |
Audio Distortion | Less than 10% |
Battery | 7.2 V, 1400 mAh Ni-MH |
Identifies and describes controls on the top and front of the radio.
Identifies and describes controls on the side of the radio.
Details primary, secondary, and third functions of keypad keys.
Steps to turn the transceiver on and off.
How to set the audio volume for listening.
Procedure for setting the squelch threshold.
Methods for tuning to different frequencies.
How to transmit signals using the transceiver.
Adjusting the transmit power output (High, Mid, Low).
How to lock the keypad and dial to prevent accidental changes.
Setting up CTCSS tones for repeater access.
Setting up Digital Code Squelch (DCS).
Setting up Enhanced Paging & Code Squelch.
Procedure for storing frequencies and settings into memory.
How to recall stored memory channels.
Organizing memories into banks for easier management.
Performing manual and programmed VFO scans.
Initiating memory scanning.
Two-channel scanning for VFO, Memory, or HOME channel priority.
Activating the emergency feature to alert others.
Automatic ID transmission for search and rescue.
Procedures for resetting various settings to factory defaults.
Procedure to activate and navigate the Set Mode menu.
Reference table for all available Set Mode items and functions.
Comprehensive guide to all Set Mode parameters and options.
General technical specifications of the transceiver.
Technical specifications for the transmitter section.
Technical specifications for the receiver section.