What to do if Yaesu ZCUT-9GR Dispenser doesn't feed tape in AUTO mode?
If your Yaesu Dispenser doesn't feed the next piece of tape in AUTO mode, first ensure that the mode is set to AUTO. If it is already set, check the sensors for any debris and remove it. If the tape is too wide, use a separator to narrow the tape to less than 25mm. Also, avoid strong light near the sensors, as tape with extremely low reflectance can be the cause.
Why Yaesu ZCUT-9GR Dispenser power is on but the machine won't run?
If your Yaesu Dispenser's power switch is on but the machine doesn't run, check the AC cord to ensure it's firmly plugged into the outlet. If the cord is secure, the fuse may have blown. Replace the fuse, and if it blows again, stop using the machine immediately.
How to fix incorrect tape length on Yaesu ZCUT-9GR?
If the tape length from your Yaesu Dispenser is inconsistent with the set length, it might be due to the tape's adhesive or elasticity being too strong. Correct the setting after cutting several test pieces to adjust for these properties.
What to do if tape curls excessively on Yaesu Dispenser?
Excessive tape curling from your Yaesu Dispenser can be caused by the machine not being grounded. Check the ground on the cord. Another cause can be that the roller lock is disengaged. Engage the roller lock to apply tension and prevent curling.
How to fix Yaesu ZCUT-9GR blade that won't move smoothly?
If the blade of your Yaesu Dispenser doesn't move smoothly, the blade unit might not be in the correct position. Check the blade unit and push down on the housing firmly.
Procedure for removing residue from the blade unit using alcohol or a swab.
Instructions for lubricating the blade and lower blade guide with blade oil.
To Next Page
General