Yak 18T Flight Operations Manual
Page 25 of 82
Disclaimer: This manual is to be used as a reference only, it is based on translated Yak 18T Flight Operations
Manuals and has not been approved by the Yakovlev Design Bureau or any other authority.
After entering the cockpit, the pilot should proceed as follows –
94. PUT feet on the rudder pedals under the pedal belts and, if necessary,
ADJUST the seat so as to be able to fully deflect the rudder pedals and the
yoke to their full extent
95. CHECK to be sure of easy and positive action of the yokes and rudder pedals
and of the correctness of the controls and ailerons for FULL AND FREE
deflection
96. CHECK whether the parachute spring hook is attached to the pull ring on the
seat pan
97. CHECK to ensure that the seat harness release is intact
98. FASTEN waist and shoulder straps and press yourself to the seat back and
tighten waist straps in the buckles. By means of a handle of the tightening
mechanism retract and lock the shoulder straps and then tighten the buckles
– ensure that you can still REACH all necessary instruments
99. CONNECT the radio communications headsets
100. CHECK whether the cockpit's doors are closed and properly clamped in the
locked position with by the latch and the lock
101. CHECK for the proper state of the flight and navigation instruments as well
as other instruments, SET the altimeter pointer to zero and check whether
the altimeter barometric pressure corresponds to the actual value at the
aerodrome level pressure at a given moment (with a difference of not more
than +1.5mm of Hg.)
102. CHECK clock reading, wind it up and SET the correct time and reset the
counter
To Next Page
Loading...