15
Maintenance and care
Maintenance and ca re
Servicing guidelines
Maintenance and care
Lubricating drive shaft
Inspect the drive shaft (A) every 25 hours of use and replenish
grease if it is insufficient.
Angle transmission
1. Remove the plug (A) and drain screw (B) from the angle
transmission (C).
2. Add grease into the transmission until old grease is pushed
out. If necessary, use a low pressure pump.
3. Reinstall the drain screw and plug.
WARNING
Observe the following precautions when checking and maintaining your product after use:
Turn the engine off and do not attempt to check or maintain the product until the engine has cooled.
You could burn yourself.
Remove the spark plug cap before performing checks and maintenance.
An accident could occur if the product starts unexpectedly.
IMPORTANT
Checking and maintenance requires specialist knowledge. If you are unable to check and maintain the product or deal with a
fault yourself, consult your dealer. Do not attempt to dismantle the product.
For spare parts and consumables, please use only genuine parts and designated products and components. Using parts from
other manufacturers or non-designated components may result in a malfunction.
Area Maintenance Page Before use Monthly
Drive shaft Grease 15 •*
Angle transmission Grease 15 •**
Cut off knife Inspect/Clean - •
Screws, bolts and nuts Inspect, Tighten/Replace - •
* Or 25 hours, whichever occurs first. ** Or 50 hours, whichever occurs first.
IMPORTANT
Time intervals are maximum. Actual use and your experience will determine the frequency of required maintenance.
If you have any questions or problems, please contact your dealer.
NOTE
Use good quality lithium multi grease.
NOTE
Use good quality lithium multi grease.
To Next Page
Loading...