Yamabiko ECHO SRM-420TES - 7 Cutter Drive System; Replacing Drive Shaft

SRM-420ES, SRM-420TES
T410S, B410S
T410TS, B410TS
50
CUTTER DRIVE SYSTEM
50
7 CUTTER DRIVE SYSTEM
(A) PTO (Driven) Shaft
(B) Ball bearing
(C) Ball bearing (
Only for SRM-420TES, T410TS and B410TS
)
(D) Retaining ring
(E) Retaining ring (
Only for SRM-420TES, T410TS and B410TS
)
(F) Washer
(G) Adapter plate
(H) Drive gear
(J) Driven gear
(K) Gear case
(L) Blade fi xture
(M) Cover plate
7-1 Replacing drive shaft
1. Separate main pipe (A) from engine by loosen-
ing bolts (B).
NOTE:
For U handle type, refer to “3-5 Replacing
ignition switch”.
2. Pull out drive shaft (C) from main pipe (A).
3. Inspect drive shaft for damage, distortion, and
both ends of shaft for wear. Replace the shaft as
required.
(L)
(K)
(E)
(D)
(M)
(A)
(C)
(B)
(F)
(G)
(H)
(J)
A
B
C