Yamaha 405 - Page 44

Effect Parameter List / Liste der Effektparameter / Liste des paramètres d’effets / Lista de parámetros de efectos
CVP-409/407/405/403/401 Data List
44
PHASER 1, EP PHASER1, 2, 3
(Chorus and all the DSP blocks)
PHASER 2
(CVP-405/403/401: DSP1, Other models: Chorus and all the DSP blocks)
DIST HEAVY
OVERDRIVE
(All the DSP blocks)
COMP+DIST1,2
(CVP-405/403/401: DSP1, Other models: all the DSP blocks)
ST DIST
ST OD
(CVP-405/403/401: DSP1, Other models: all the DSP blocks)
AMP SIM1, DIST HARD, DIST HARD2, DIST SOFT, DIST SOFT2
(All the DSP blocks)
ST AMP1, 3, 4, ST DIST HARD, ST DIST SOFT (*4)
ST AMP2, 5, 6
(CVP-405/403/401: DSP1, Other models: all the DSP blocks)
AMP SIM2
(CVP-405/403/401: DSP1, Other models: all the DSP blocks)
No. Parameter Display Value See Table Control
1 LFO Frequency 0.00Hz – 39.7Hz 0 – 127 table#1
2 LFO Depth 0 – 127 0 – 127 (table#19)
3 Phase Shift Offset 0 – 127 0 – 127
4 Feedback Level -63 – +63 1 – 127 (table#16)
5
6 EQ Low Frequency 32Hz – 2.0kHz 4 – 40 table#3
7 EQ Low Gain -12 – +12dB 52 – 76
8 EQ High Frequency 500Hz – 16.0kHz 28 – 58 table#3
9 EQ High Gain -12 – +12dB 52 – 76
10 Dry/Wet D63>W – D=W – D<W63 1 – 127 (table#15) ●
11 Stage 4 – 22 (*2) 4 – 22
4 – 12 (*3) 4 – 12
12 Diffusion mono/stereo 0 – 1
13
14
15
16
No. Parameter Display Value See Table Control
1 LFO Frequency 0.00Hz – 39.7Hz 0 – 127 table#1
2 LFO Depth 0 – 127 0 – 127 (table#19)
3 Phase Shift Offset 0 – 127 0 – 127
4 Feedback Level -63 – +63 1 – 127 (table#16)
5
6 EQ Low Frequency 32Hz – 2.0kHz 4 – 40 table#3
7 EQ Low Gain -12 – +12dB 52 – 76
8 EQ High Frequency 500Hz – 16.0kHz 28 – 58 table#3
9 EQ High Gain -12 – +12dB 52 – 76
10 Dry/Wet D63>W – D=W – D<W63 1 – 127 (table#15) ●
11 Stage 3 – 11 3 – 11
12
13 LFO Phase Difference -180deg – +180deg
(resolution=3deg.)
4 – 124
14
15
16
No. Parameter Display Value See Table Control
1 Drive 0 – 127 0 – 127 ●
2 EQ Low Frequency 32Hz – 2.0kHz 4 – 40 table#3
3 EQ Low Gain -12 – +12dB 52 – 76
4 LPF Cutoff 1.0kHz – Thru 34 – 60 table#3
5 Output Level 0 – 127 0 – 127 (table#18)
6
7 EQ Mid Frequency 100Hz – 10.0kHz 14 – 54 table#3
8 EQ Mid Gain -12 – +12dB 52 – 76
9 EQ Mid Width 0.1 – 12.0 1 – 120
10 Dry/Wet D63>W – D=W – D<W63 1 – 127 (table#15)
11 Edge (Clip Curve) 0 – 127 (mild – sharp) 0 – 127
12
13
14
15
16
No. Parameter Display Value See Table Control
1 Drive 0 – 127 0 – 127 ●
2 EQ Low Frequency 32Hz – 2.0kHz 4 – 40 table#3
3 EQ Low Gain -12 – +12dB 52 – 76
4 LPF Cutoff 1.0kHz – Thru 34 – 60 table#3
5 Output Level 0 – 127 0 – 127 (table#18)
6
7 EQ Mid Frequency 100Hz – 10.0kHz 14 – 54 table#3
8 EQ Mid Gain -12 – +12dB 52 – 76
9 EQ Mid Width 0.1 – 12.0 1 – 120
10 Dry/Wet D63>W – D=W – D<W63 1 – 127 (table#15)
11 Edge (Clip Curve) 0 – 127 (mild – sharp) 0 – 127
12 Attack 1ms – 40ms 0 – 19 table#8
13 Release 10ms – 680ms 0 – 15 table#9
14 Threshold -48dB – -6dB 79 – 121
15 Ratio 1.0 – 20.0 0 – 7 table#10
16
No. Parameter Display Value See Table Control
1 Drive 0 – 127 0 – 127 ●
2 EQ Low Frequency 32Hz – 2.0kHz 4 – 40 table#3
3 EQ Low Gain -12 – +12dB 52 – 76
4 LPF Cutoff 1kHz – Thru 34 – 60
5 Output Level 0 – 127 0 – 127 (table#18)
6
7 EQ Mid Frequency 100Hz – 10.0kHz 14 – 54 table#3
8 EQ Mid Gain -12 – +12dB 52 – 76
9 EQ Mid Width 0.1 – 12.0 1 – 120
10 Dry/Wet D63>W – D=W – D<W63 1 – 127 (table#15)
11 Edge (Clip Curve) 0 – 127 0 – 127
12
13
14
15
16
No. Parameter Display Value See Table Control
1 Drive 0 – 127 0 – 127 ●
2 AMP Type Off, Stack, Combo, Tube 0 – 3
3 LPF Cutoff 1.0kHz – Thru 34 – 60 table#3
4 Output Level 0 – 127 0 – 127 (table#18)
5
6
7
8
9
10 Dry/Wet D63>W – D=W – D<W63 1 – 127 (table#15)
11 Edge (Clip Curve) 0 – 127 (mild – sharp) 0 – 127
12
13
14
15
16
No. Parameter Display Value See Table Control
1 Drive 0 – 127 0 – 127 ●
2 AMP Type Off, Stack, Combo, Tube,
Crunch, Hi gain, British
0 – 6
3 LPF Cutoff 1.0kHz – Thru 34 – 60 table#3
4 Output Level 0 – 127 0 – 127 (table#18)
5
6
7
8
9
10 Dry/Wet D63>W – D=W – D<W63 1 – 127 (table#15)
11
12
13
14
15
16
No. Parameter Display Value See Table Control
CVP_DL_Multi.book 44 ページ ２００６年１２月２１日 木曜日 午後２時５７分