Pre-operation checks
91
SX195/SX190
1 Bow light
2 Anchor light
(3) Push the bottom of the navigation and
anchor lights switch and check that only
the anchor light comes on.
(4) Put the navigation and anchor lights
switch in the middle position and check
that the bow light and anchor light are off.
(5) Remove the anchor light.
Horn switch check
Push the horn switch and check that the horn
sounds.
1 Horn switch
Engine shut-off cord (lanyard) check
Make sure that the engine shut-off cord (lan-
yard) is not damaged. If the cord is damaged,
replace it. WARNING! Never try to repair
the engine shut-off cord (lanyard) or tie it
together. The engine shut-off cord (lan-
yard) may not pull free when the operator
falls off, allowing the boat to continue to
run and cause an accident.
Post-launch checks
Perform the post-launch checks in the pre-op-
eration checklist while the boat is in the water
and the engine is running.
Engine shut-off switch check
Check the engine shut-off switch for proper
operation.
(1) Start the engine. (See page 93 for infor-
mation on starting the engine.)
(2) Pull the engine shut-off cord (lanyard) to
remove the clip from the engine shut-off
switch to make sure that the engine stops
immediately.
(3) Make sure that the engine cannot be
started with the clip removed from the en-
gine shut-off switch.
SportsBoat_F4B10.book Page 91 Thursday, June 2, 2016 10:08 AM
Downloaded from ManualsNet.com search engine
To Next Page
