4-154-14
CHOKE CABLE ADJUSTMENT
Pull the choke knob out until it stops.
Release the knob. The knob should not
move. If it moves back on its own, tight-
en the friction adjustment slightly. If the
knob is difficult to move, loosen the fric-
tion adjustment slightly.
REVERSE GATE MECHANISM
INSPECTION
1) Remove the engine stop switch lan-
yard and ignition keys.
2) Put the throttle levers in the idle
position (otherwise the shift lever
will not move).
3) Push the shift lever to Forward from
the Neutral position while a second
person observes shift gate move-
ment from outside the boat. Both
shift gates should lift completely to
the stops.
4) Pull the shift lever back from
Forward through Neutral to
Reverse. The observer should
check for proper movement of the
shift gates. Both gates should drop
down over the nozzles to the stops.
If reverse gates do not operate smooth-
ly or correctly, ask your authorized
Yamaha Sport Boat dealer for service.
FUSE REPLACEMENT
The fuse is in the ignition coil holder. To
replace the fuse, unscrew the cap and
pull the two red leads out with the fuse
holder. Open the fuse holder and
replace the fuse.
➀ Ignition coil holder ➂ Fuse (10A)
➁ Cap 4 Fuse holder
Accessory Fuse
➀ Fuse (20A)
➁ Accessory lead
The fuse is on the accessory battery
lead wire (red with black stripe). Open
the fuse box and replace the fuse.
1
2
STEERING CABLE INSPECTION
Be sure to check:
1) Check for smooth operation of the
wheel and steering nozzles.
2) Check for proper steering adjust-
ment. The nozzles should both point
straight back when the steering
wheel is centered.
If steering is stiff or misadjusted, ask
your Yamaha dealer to service it.
THROTTLE CABLE INSPECTION
Push and pull the throttle levers
through their full range with the shift
lever in Neutral. Repeat with the shift
lever in Forward, and again in Reverse.
Both throttle levers should move
smoothly from idle to full throttle and
back. If not, ask your Yamaha Sport
Boat dealer for service.
Improper throttle operation could
result in an accident. Check for
proper throttle operation before
starting the engines.
To Next Page
