Yamaha Electone ME-35A User Manual

1. Tranferring Information to a Pack
PACK
It is possible for the information of Registration Memory and of C.S.P. (see Page 19) that has
been memorized into the Electone to be transferred to a RAM Pack (optional). Also, the
Information transferred to a RAM Pack can be transferred back to the Electone.
How
to
Transfer
Information
to
a
RAM
Pack
(TO
PACK)
1 Memorize the desired information into Registration Memory or C.S.P.
(See pages 13 and 19.)
2 Insert a RAM Pack (RP-3) into the Electone.
Insert the RAM Pack securely into the Electone so that
its top side (with the label) faces left. The green
READY lamp will light up.
PACK:
- Γη
READY ERROR
CONFIRM FROM PACK
“fs
pcr al
With the CONFIRM button pressed down, press the TO PACK button. (The TO PACK
button also functions as the MEMORY button of Registration Memory.)
The READY lamp will flash several times to indicate that the Electone’s information has
been transferred to the RAM Pack.
How to Return Information from the RAM Pack
(FROM PACK)
1
Insert
the
RAM
Pack,
which
contains
the
transferred
information,
into
the
Electone.
The
green
READY
lamp
will
light up.
: 2 While depressing the CONFIRM button, press the
FROM PACK button.
With the CONFIRM button pressed down, press the
FROM PACK button.
The READY lamp will flash to indicate that the
information of the RAM Pack has been transferred SEU. gon
back
to
the
Electone.
=
so
[MEMORY PROTECT]
MEMORY
PROTECT
ON @=— OFF}
~
If you wish to prevent the information that was
transferred to the RAM Pack from being erased,
set the MEMORY PROTECT switch of the RAM
Pack to “ON”. Even if you later unintentionally
attempt a TO PACK operation, the information
previously memorized into the RAM Pack will be
protected without the new information being
memorized. (The FROM PACK operation, how-
ever, can be executed.) Furthermore, if you wish
to memorize new data onto that RAM Pack at a
later time, just return the MEMORY PROTECT
Switch to "OFF".
[If the ERROR lamp flashes]
In the following cases, the red ERROR lamp will
flash for about one second and the alarm will
sound three times. Please check that you are
using the proper operating procedures.
€ When an unused RAM Pack is first inserted
into the electone. (In this case, press the
CONFIRM button then perform the TO PACK
operation.)
€ When the Pack is not completely inserted.
€ When a TO PACK operation is attempted while
the MEMORY PROTECT switch of the RAM
Pack is set to "ON".
€ When the information memorized in the RAM
Pack is for an Electone of a different model.
[Precautions on RAM Pack Use]
€ When a TO PACK operation is performed, the
previously stored information in that RAM
Pack is erased and written over with the new
information. When the FROM PACK operation
is performed, the previously stored information
in the Electone is erased and written over with
the information from the RAM Pack.
€ When transferring information memorized in a
RAM Pack back to an Electone, be sure that an
Electone of the same model is being used.

Yamaha Electone ME-35A Specifications

General

Brand	Yamaha
Model	Electone ME-35A
Category	Musical Instrument
Language	English