Yamaha F6A - Operation

GB
EMU00174
Chapter 3
OPERATION
INSTALLATION
......................................3-1
Mounting the outboard motor...............3-3
Clamping the outboard motor ..............3-7
BREAKING IN (RUNNING IN) ENGINE
....3-9
PRE-OPERATION CHECKS
................3-11
Checking the engine oil level .............3-13
FILLING FUEL
......................................3-15
STARTING ENGINE
.............................3-17
Procedure for tiller control model.......3-19
Procedure for remote control
model .................................................3-25
WARMING UP ENGINE
........................3-29
CHECKING POINTS AFTER
STARTING ENGINE
.............................3-29
SHIFTING
.............................................3-31
Forward..............................................3-31
Reverse .............................................3-33
STOPPING ENGINE
.............................3-37
TRIMMING OUTBOARD MOTOR
........3-41
Adjusting trim angle ...........................3-43
TILTING UP/DOWN
..............................3-49
Procedure for tilting up.......................3-51
Procedure for tilting down ..................3-51
Procedure for tilting up.......................3-53
Procedure for tilting down ..................3-53
CRUISING IN SHALLOW WATER
.......3-55
Procedure ..........................................3-57
Returning to original position .............3-59
CRUISING IN SHALLOW WATER
.......3-61
Procedure ..........................................3-61
CRUISING IN OTHER CONDITIONS
...3-63
Cruising in salt water .........................3-63
Cruising in turbid water ......................3-63
U68T73A0.book Page 1 Sunday, March 30, 2003 6:34 PM