EasyManuals Logo

Yamaha FX High Output WaveRunner 2007 User Manual

Yamaha FX High Output WaveRunner 2007
116 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #72 background imageLoading...
Page #72 background image
Operation
67
(1) If the lock mode of the Yamaha Security
System is selected, use the remote con-
trol transmitter to select the unlock mode.
(See page 38 for Yamaha Security Sys-
tem and low-RPM mode selection proce-
dures.)
(2) Launch the watercraft in water free from
weeds and debris and at least 60 cm (2 ft)
deep.
WARNING
EWJ00570
Never operate in water that is less than 60
cm (2 ft) deep, otherwise you increase
your chance of hitting a submerged ob-
ject, which could result in injury.
CAUTION:
ECJ00470
Never operate in water that is less than 60
cm (2 ft) deep, otherwise pebbles or sand
could be sucked into the jet intake, caus-
ing impeller damage and engine overheat-
ing.
(3) Attach the engine shut-off cord to your left
wrist, and then attach the clip to the en-
gine shut-off switch.
WARNING
EWJ00580
Check that the engine shut-off cord is not
frayed or broken, and keep it free from the
handlebars so that the engine stops if the
operator falls off. The engine shut-off cord
may not pull free if wrapped around the
handlebars when the operator falls off, al-
lowing the watercraft to continue to run
and cause an accident.
NOTE:
It is not possible to start the engine with the
clip removed from the engine shut-off switch.
1 Clip
2 Engine shut-off switch
3 Engine shut-off cord
UF1X11E0.book Page 67 Monday, August 7, 2006 3:51 PM

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yamaha FX High Output WaveRunner 2007 and is the answer not in the manual?

Yamaha FX High Output WaveRunner 2007 Specifications

General IconGeneral
BrandYamaha
ModelFX High Output WaveRunner 2007
CategoryBoat
LanguageEnglish

Related product manuals