FCC INFORMATION (U.S.A.)
1.
IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT!
This product, when installed as indicated
in
the instructions contained in this manual, meets FCC requirements.
Modifications not expressly approved
by
Yamaha may void your authority, granted by the FCC, to use the product.
2.
IMPORTANT: When connecting this product to accessories and/or another product use only high quality shielded
cables. Cable/s supplied with this
product
MUST be used. Follow all installation instructions. Failure to follow
instructions could void your FCC authorization to use this product
in
the USA.
3.
NOTE: This product has been tested and found to comply with the requirements listed
in
FCC Regulations, Part
15
for Class "B" digital devices. Compliance with these requirements provides a reasonable level of assurance that your
use of this product
in
a residential environment will not result
in
harmful interference with other electronic devices.
This equipment generates/uses radio frequencies and, if not installed and used according to the instructions found
in the users manual, may cause interference harmful to the operation of other electronic devices. Compliance with
FCC regulations does not guarantee that interference will not occur in all installations. If this product is found to be
the source of interference, which can be determined by turning the unit "OFF" and "ON" , please try to eliminate the
problem by using one of the following measures:
- Relocate either this product
or
the device that is being affected by the interference.
- Utilize power outlets that are on different branch (circuit breaker or fuse) circuits or install AC line filter/s.
-
In
the case of radio or TV interference, relocate/reorient the antenna. If the antenna lead-in is
300
ohm ribbon lead,
change the lead-in to co-axial
type
cable.
If these corrective measures
do
not produce satisfactory results, please contact the local retailer authorized to
distribute this type of product. If you cannot locate the appropriate retailer, please contact Yamaha Corporation of
America,
6600
Orangethorpe Avenue, Buena Park, CA 90620, U.S.A.
The above statements apply ONLY to those products distributed
by
Yamaha Corporation of America or its
subsidiaries.
(529-M04
FCC
class B
YCA
02)
COMPLIANCE INFORMATION STATEMENT
(Supplier's
declaration
of
conformity
procedure)
Responsible Party: Yamaha Corporation of America
Address: 6600 Orangethorpe Avenue, Buena Park, CA. 90620, U.S.A.
Telephone: 714-522-9011
Type of Equipment: POWERED SPEAKER SYSTEM
Model Name: HS4, HS3
This device complies with Part
15
of the FCC Rules.
Operation is subject to the following two conditions:
1)
this device may not cause harmful interference, and
2) this device must accept any interference received, including interference that may cause undesired operation.
The model number, serial number, power requirements, etc., may be found on or near the name plate, which is at
the rear of the unit.
You
should note this serial number
in
the space provided below and retain this manual as a
permanent record of your purchase to aid identification in the event of theft.
Model No.
Serial No.
Yamaha
Pro
Audio
global
website
https ://www. yamahaproaud io.
com/
Yamaha
Downloads
https://download.yamaha.com/
(1003-M06 plate rear en 01)
© 2023 Yamaha Corporation
Published 05/2023
MWEI-AO
To Next Page
Loading...
