Yamaha MT-09 SP User Manual

Special features
4-7
4
WARNING
EWA16351
It is dangerous to use the resume
function when the previously set
cruising speed is too high for current
conditions.
Turning off the cruise control sys-
tem
At any time, press the cruise control
power button “ ” to turn off the
cruise control system completely. Both
the cruise control indicator “ / ”
and the set speed indicator “ / ” will
go off.
TIP
Whenever the cruise control system or
the vehicle power is turned off, the pre-
viously set cruising speed is erased.
You will not be able to use the resume
function until a new cruising speed has
been set.
Automatic deactivation of the cruise
control system
The cruise control system is electroni-
cally controlled and linked with other
control systems. The cruise control
system will automatically deactivate
under the following conditions:
 The cruise control system is not
able to maintain the set cruising
speed (such as when going up a
steep hill).
 Wheel slip or wheel spin is detect-
ed. (If the traction control system
is on, traction control will engage.)
 Stop/Run/Start switch “ / / ”
is set to “ ”.
 Engine is stopped.
 Side stand is lowered.
 Traction control system is turned
off.
If the cruise control system turns off
under the above conditions, the cruise
control indicator “ / ” and the set
speed indicator “ / ” will flash for 4
seconds before turning off.
To use the cruise control system again,
press the cruise control power
button “ ” to turn on the system.
TIP
When traveling uphill or downhill, the
cruise control system may, in some
cases, fail to maintain the set cruising
speed.
 When the vehicle is traveling up-
hill, the actual traveling speed may
become lower than the set cruis-
ing speed. If this occurs, acceler-
ate to the desired traveling speed
using the throttle.
 When the vehicle is traveling
downhill, the actual traveling
speed may become higher than
the set cruising speed. If this oc-
curs, the setting switch cannot be
used to adjust the set cruising
speed. To reduce the traveling
speed, apply the brakes. When
the brakes are applied, the cruise
control system will become deac-
tivated.
UBMME0E0.book Page 7 Tuesday, March 12, 2024 2:37 PM

Yamaha MT-09 SP Specifications

General

Displacement	889cc
Bore x Stroke	78.0 mm x 62.1 mm
Compression Ratio	11.5:1
Maximum Torque	93.0 Nm (9.5 kg-m) @ 7, 000 rpm
Fuel System	Fuel Injection
Starter System	Electric
Transmission	6-speed
Final Drive	Chain
Length	2, 090 mm
Height	1, 190 mm
Seat Height	825 mm
Wheelbase	1, 430 mm
Ground Clearance	140 mm
Wet Weight	193 kg
Fuel Tank Capacity	14 L
Engine Type	Liquid-cooled, 4-stroke, DOHC, 4-valve
Maximum Power	119 PS (87.5 kW) @ 10, 000 rpm
Front Brakes	Hydraulic dual disc, 298 mm
Rear Brakes	Hydraulic single disc, 245 mm
Front Tire	120/70ZR17
Rear Tire	180/55ZR17