To Next PageTo Next PageHow to troubleshoot a Yamaha Diving vehicle that won't turn on?
If your Yamaha Diving vehicle isn't working, ensure that: 1. The Master Switch is turned ON. 2. The Battery Pod is fully charged. 3. The battery compartment is dry.
What to do if there is sand or grit on the O-ring seal of my Yamaha Diving vehicle?
If you find sand or grit on the O-ring Seal of your Yamaha Diving vehicle, follow these steps: * Rinse the O-ring Seals in fresh water and apply fresh lubricant. * If there is sand inside the Battery Housing, gently brush the sand from the unit, being careful not to scratch the sealing surfaces. * If an O-ring Seal is damaged, replace it with a new one and apply fresh lubricant before use.
What to do if the propeller of my Yamaha Diving vehicle is blocked?
If the Propeller of your Yamaha Diving vehicle becomes blocked, open the Protective Grilles to remove the obstacle.
General| Brand | Yamaha |
|---|---|
| Model | SEASCOOTER 275L |
| Category | Diving vehicles |
| Language | English |
Explicitly states the seascooter is not a life-saving device or buoyancy aid.
Prohibits alcohol or drug use prior to and during product operation.
Details safety around battery charging, including waiting after charging.
Warns that heat can damage batteries, causing them to explode or leak.
Instructs to always remove the battery pod when not in use and not store it inside the unit.
Guides on fitting and lubricating rubber seals in grooves before replacing the nose cone.
Emphasizes recharging the battery at least every three months when not in use.
States the battery must be removed and stored separately when not in use.
Requires recharging the battery within 24 hours after use.
Strongly advises against replacing the original battery with an aftermarket one.
Warns that modifications by unauthorized parties void the warranty.
Warns that batteries release potentially explosive gases during use and charging.
Instructs to store batteries separately in a well-ventilated area away from hazards.
Prohibits charging/storing batteries above 40°C (104°F) due to off-gassing.
Mandates using only the supplied charger with the seascooter.
States charging must occur in a well-ventilated area away from ignition sources.
Advises charging the battery as soon as possible after use, within 24 hours.
Warns that batteries emit gas after charging and require a 30-minute wait.
Prohibits charging the battery in a sealed container.
Prohibits charging the battery near water.
Warns against short-circuiting the battery or its connectors.
Advises replacing the battery if damaged, not charging fully, or if life is reduced.
Urges immediate battery replacement if damaged.
Provides step-by-step instructions for removing the nose cone.
Explains pumping air into the vent chamber until the nose cone pops off.
Emphasizes attaching the rubber ring to prevent injury from the popping nose cone.
Details plugging in the base and the charging duration (12-14 hours).
Emphasizes cleaning and lubricating O-ring seals and sealing surfaces.
Ensures the Vent O-Ring is correctly fitted and lubricated in its groove.
Refers to battery safety information and warns about excess off-gassing.
Reiterates removing the battery pod immediately and not storing it in the seascooter.
Lists checks for when the propeller does not start, including switch and battery charge.
Explains how to handle a blocked propeller and the risks of turning it on.
Advises ensuring the master switch is off and the battery is disconnected.
Instructs to disconnect and remove the battery pod before proceeding.
Details unscrewing twelve grille screws to remove the inner nozzle and propeller nozzle.
Guides on using an M6 socket wrench to remove the nut from the propeller shaft.
Explains sliding the propeller off the shaft, keeping track of drive pin and washers.
Directs to remove any blockage from the propeller or propeller shaft.
Details replacing the drive pin and propeller, ensuring proper alignment.
Guides on replacing the washer and nut, tightening securely.
Explains cleaning and lubricating O-ring seals to remove sand or grit.
Prohibits operating the unit with a suspected leak in the motor chamber.
Explicitly states the battery is not included in this warranty.
Warns that using an aftermarket battery will void coverage.
